Company News

Home News Company News

Application of inclination senso

Jun 04,2020 516

Tilt sensors are used for a variety of Angle measurement applications. Such as: high precision laser equipment level, engineering machinery and equipment level, remote distance meter, high altitude platform security protection, directional satellite communication antenna pitching Angle, vessel navigation attitude measurement, the application of shield pipe jacking, dam detection, initial firing Angle measurement equipment slope monitoring, barrel, radar detecting vehicle platforms, satellite communication vehicle posture, etc.

Application editing sounds

Angle measurement, zero adjustment, level adjustment

Tilting switch (12 switching signals)

Security control, alarm and monitoring

Angle measurement of manipulator, dam, building and bridge

Alignment control, bending control.

Initial position control, inclination and attitude recorder

Application characteristics

Uniaxial dip sensors based on capacitive 3D-MEMS technology demonstrate reliability, exceptional stability and unprecedented precision over the full temperature range. Tilt Angle sensors series tilt Angle sensors are designed, manufactured and tested to meet the reliability and stability requirements of the automotive industry. The series tilt Angle sensor has significant load capacity and very good impact durability without the need for additional components. Tilt sensor is one of the analog acceleration sensor products, and fully compatible with the acceleration sensor.

Biaxial tilt sensor

The tilt sensor can adjust the output frequency and has a built-in zero adjustment function. Can be customized according to the requirements of the zero button, to achieve a certain Angle of the zero function. This is very useful in cases where you want to measure the relative inclination and you can return to the zero position after use. The tilt sensor is used on such occasions as long as the sensor is fixed on a certain plane, and the zero button is used to achieve the zero reset function of measuring before reading the data from the sensor after the relative tilt Angle on the aircraft.

The filter function

When the output is required to be stable, it is recommended to use a relatively flat output. In this way, the output value tends to be flat and does not change drastically. If very timely output is required, such as when measuring higher frequency vibrations, high-frequency output can be used, but the output will be unstable due to the short response time. At the same time, the internal filtering function can be used to measure the inclination Angle under vibration condition.

Angle measurement

Its principle is through the coordination of two axes, in the form of Euler Angle to express the rotation of a coordinate system, can realize the measurement of 360 degrees of inclination. The product is already stable. In some cases where full-size inclination measurements are required, the ideal choice is a 360-degree product.

The application

  1. Used for agricultural dump trucks

Due to the dump truck usually work in a certain slope environment, a large number of dump truck manufacturers installed a dual-axis tilt sensor on the dump truck, and designed a special display to display the Angle measured by the sensor, providing reliable reference data for drivers to drive safely. Not only that, when the dump truck is driving on a relatively level road, the tilt Angle sensor can also measure the current tilt Angle during the driving process, providing accurate reference data for the small changes in the body structure.

  1. Suitable for tower crane

Tilt sensor is the main component of tilt monitoring instrument for tower crane. The function of the tilt sensor is to measure the tilt Angle of the tower in real time. Since the tilt Angle of the tower top changes very little, the sampling frequency of the tilt sensor should be in the range of 0.5-10 Hz, and the measurement accuracy should be higher than 0.05 degrees. At the same time, the noise caused by vibration should be filtered out at the top of the tower to ensure reliable communication and accurate judgment.

  1. Suitable for plate conveyor

In the installation process of plate conveyor, the dip sensor can be installed on the top of the conveyor, can directly measure the current dip Angle of the conveyor, greatly simplifying the installation process. In the process of use, the software can also set the alarm Angle, save time and effort. It can be seen that the inclination sensor instead of the previous flat conveyor installed according to experience, greatly improve the installation speed and work efficiency.

  1. Suitable for CNC machine tools

In the process of machining nc machine parts。

Applications

Related Industry Knowledge
Related Products